11/12/2022 0 Comments Modbus tcp 400000![]() This is the default port for Modbus TCP Protocol. ![]() Since the Click PLC will be configured as a Server (Slave), ensure that the TCP Port Number is set for 502. The default gateway will be left at 0.0.0.0 so it is not exposed to the internet. We will use the manual settings for the Network Address Configuration. You will notice that the Modbus protocol is already selected. You can access the Com Port Setup by using the main menu | Setup | Com Port Setup… The first thing that we will do is set up the Click PLC Ethernet port. Click PLC Configuration – Modbus TCP Server ![]() This includes the existing 10, plus the 10 read registers from the 3rd PLC. We would then write 20 registers to the Click PLC. Read 10 registers and write 20 registers from and to the 3rd PLC. Note: If we wish to extend our network with a third PLC that would share information to the network we would do the following. We will be writing and reading 10 16bit registers each to and from the Click PLC from our Productivity 1000 PLC.ĭH1 -– P1000_Net_Write1 – Bit 1 = Heartbeat Bit (1sec on 1sec off)ĭH12- P1000_Net_Read2 = Throughput Time Captured Productivity to Click PLC – System Configuration Watch the video below to see the running and configuration of the Modbus TCP Ethernet Communication from the Productivity 1000 Series PLC to the Click PLC. Numbering Systems and Tag Database – Videoĭata Handling Instructions Part 1 – Videoĭata Handling Instructions Part 2 – Video ![]() Monitoring and Testing the Program – Video Previously in this Productivity 1000 series PLC we have discussed: Productivity 1000 Series PLC Modbus TCP Ethernet Communication ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |